When a test case is run, the results are stored as test case run. For each test case run, you can review the test results, and if applicable do the manual tests.
The status is shown in these ways:
- Test step status in the Result section:
The test step status can be automatically set to: - Passed: If the test step result matches with the expected status, the test step Status is set to Passed.
- Failed: If the test step result does not match with the expected status, the test step Status is set to Failed.
- New: The mapping cannot be done because there is no value to be set.
- Test case run status in the Test case run section:
The test case run status field can automatically be set to: - Passed: If for all test steps, for all tested records, the status is Passed, the test case run status is set to Passed.
- Failed: If for at least one of the steps, for at least one of the tested records, the status is Failed, the test case run status is set to Failed.
- No data: If the test case cannot be done because no data was available to be processed, the test case run status is set to No data.
A test case can fail, for example, caused by errors or by a test step that must be tested manually. You can review a failed test case and, if applicable, manually test the manual test steps.
After reviewing and manual testing, you can manually change the test case run status in line with your findings.
Standard procedure
| 1. |
Go to Connectivity studio > Inquiries > Test case run. |
| 2. |
In the list, find and select the desired test case run. |
| 3. |
Click Edit. |
| 4. |
In the Test status field, select an option. |
| 5. |
Close the page. |